Applications
Choose by application: constraints first, grade second
Every application page gives four things: the constraints that actually decide the part, a side-by-side comparison of mainstream options, three common misjudgements, and the matching Himing grades. If you have a drawing and a duty cycle, start from the constraints — it is faster than reading a grade table.
Battery pack lids
The four hard requirements behind GB 38031, and how steel, die-cast aluminium, SMC, LFT and short-glass PA66 compare.
See the selection points →Rail fastening systems
CRCC approval comes before performance: -40 to 80 °C, 1000 h salt spray, 20-year life and insulation.
See the selection points →Under-hood parts
Set the base resin from the local temperature; retention after ageing, oil immersion and orientation warpage are the real gates.
See the selection points →Electrical housings
UL94 is judged at the thinnest wall; glow-wire and CTI cannot be inferred from flame rating. Five options compared.
See the selection points →Antibacterial appliance parts
Efficacy, ΔE ≤ 1.5 after 200 °C processing, and durability re-test — zinc versus silver systems.
See the selection points →Corrugated conduit
Why V-0 is hard at a 0.4–0.8 mm wall, the flame-versus-flex trade-off, and where PP gives way to PA.
See the selection points →Application not listed?
Send the drawing, the temperature and the approval requirements. We reverse-engineer the material from the constraints rather than pushing an existing grade.